Installing a Hard Drive

Student Page

Introduction

Task

Process

Evaluation

Conclusion

Resources

Teacher Page

Lessons

Home

Student Process

  1. Gather the following parts and supplies necessary to complete the installation:
    • One Personal computer (see course materials list for PC specifications).
    • One IDE hard drive(aka HDD), 3GB or larger (remove all jumpers prior to issuing to students).
    • One 80-pin IDE ribbon cable with dual connectors.
    • Two pin jumpers for drive configuration.
    • One MS-DOS or Windows98 boot floppy diskette.
    • One Internet capable computer for information/driver research.
    • Internet access.
  2. What's missing above??  Ok, its the anti-static wrist strap.  Sure, you should always use one, but how many people actually do?  Do be a total geek, though.  Make sure that you touch and maintain contact with the PC chassis every time you start to put your hands inside the computer.
  3. Remove the PC cover and place it and its screws in a secure location.
  4. Perform a visual inspection of the PC's interior.  Find the existing IDE cable and HDD.  If the existing cable has an available connector you will not need the extra cable.  Also find an available power connector.
  5. Examine the existing HDD.  If it is the only drive it is almost certainly configured as the Master Drive.  You will need this information to configure the additional HDD.
  6. Attach the jumpers to the new HDD to configure it to be a Slave Drive.
  7. Find an available slot in the chassis and mount the new HDD in it.
  8. Secure the new HDD with its mounting screws.
  9. Attach the data cable to the new HDD.
  10. Attach the power cable to the HDD.
  11. Replace the cover and power cord.
  12. Power up the PC using the floppy diskette.
  13. Once the operating system has started, use the FDISK utility to partition and FORMAT the new HDD.
  14. Congratulations!!! You now have a PC with two Hard Drives.
  15. Now click on the Evaluation link to your left to check you work.


These pages were made through TeacherTECH, the teacher professional development component of GirlTECH, which is sponsored by the Center for Excellence and Equity in Education (CEEE) with support from the National Science Foundation through EPIC.